|
||
|
|
|
|
|
|
|
enjoyurlife | |
About Me My Profile Archives Friends Blogs My Photo Album LinksCategoriesRecent EntriesSleep on swill Magnetic hydroxy Hesitate on the lake2. Nylon zipper No. 3 My MomsBuzz Friends |
2. Nylon zipper No. 3
9:57 PM, May. 13, 2008
.. 0 comments
.. Link
2. Nylon zipper No. 3 It is thickness 2.00+0.05mm 2.65+0.03 wide to make 4.15+0.05 forms of width up It is high to draw the head mouth: 2.05-2.15 It is wide to draw the head mouth: 4.2-4.25 Close the end: Do not need to divide the level miaow while fixing inch, so can turn back and open sometimes; Lay and stop deploying sometimes the latitude density is simply loose and apt to present the phenomenon of reeling off raw silk from cocoons, result in aesthetic problems, had better stop width cloth take pattern adopt first knit the law in the range, it is difficult to put and stop penetrating the cloth and take and reel off raw silk from cocoons like this; On stop by position must guarantee the neat,last 2.2mm ago, and then not last 1.8mm, in front and at the back of moulding plastics take the lead if wanting, guarantee yard by 4.0mm Open end: Inch selects the tooth to be relatively difficult definitely, because the tooth distance is smaller (1.2mm) Had better select for use fixed yard put, right insert left to be high right low, need, build miaow by hand, ultra transliteration half a drop of miaow pigeonhole the root, both sides take shin distribute evenly, and pieces of line constant, punch cloth foot long about 8mm, pigeonhole pace that square draw at the socket should not be too fast, it is even for both sides to exert oneself and pull location to, keep organ must work while being slow, it is difficult for mould not to damage in this way, the pressure is transferred to under high pressure low-voltagely, slowly imprison the model, then the high-pressure movement pressure is transferred low-voltagely to the high pressure, go on, lock mould under high pressure, two reaction switches differ by about 20mm, because nylon No. 3 is relatively thin in thickness, so the switch movements of reaction are bad and relatively small, expect relatively much in adjusting the switch position of reaction, adjust the method specifically: Reaction turns on or off the light only as the noload position of zipper, go to the zipper miaow tooth and is higher than part, reaction pole movement, reaction turn on or off light put out, angle needle press, catch on, stick to cloth shut miaow hole of tooth put in place and wash. It is apt to cause the factor of nylon zipper substandard product No. 3: Because of one yard of reasons put, a line is easy to be broken when fixing inch, half a drop of miaow ultra sound waves have not been killed, cause and press and open end and draw it uncompletely. Note: Turn on need 3 # nylon it if worthy ofing, turn on unless there aren't tail, pretend yard normal tail,on stop can mould plastics Leave a Comment { Last Page } { Page 2 of 2 } { Next Page } |